IEI Integration AFL-LX-Series v2.01 - Manual (Page 88)

AFOLUX LX Series Flat Panel PC
Page 88
Master Drive PIO Mode
Slave Drive PIO Mode
Auto (Default) The computer selects the correct mode.
Mode 0 PIO mode 0 selected with a maximum transfer rate of 3.3MBps.
Mode 1
PIO mode 1 selected with a maximum transfer rate of 5.2MBps.
Mode 2 PIO mode 2 selected with a maximum transfer rate of 8.3MBps.
Mode 3 PIO mode 3 selected with a maximum transfer rate of 11.1MBps.
Mode 4 PIO mode 4 selected with a maximum transfer rate of 16.6MBps.
IDE UDMA [Auto]
Use the IDE UDMA option below to select the Ultra DMA (UDMA) mode for the following
HDDs:
IDE Primary Master UDMA
IDE Primary Slave UDMA
Disabled The UDMA for the HDD device is disabled.
Auto (Default) The computer selects the correct UDMA.
IDE DMA transfer access [Enabled]
Use the IDE DMA transfer access option to enable or disable DMA support for IDE
devices connected to the system.
Disabled All IDE drive DMA transfers are disabled. The IDE drives
use PIO mode transfers.
Enabled
(Default) All IDE drive DMA transfers are enabled.
IDE HDD Block Mode [Enabled]
If the drive connected to the system supports block mode, use the IDE HDD Block Mode
option to enable the system to detect the optimal number of block read/writes per sector