IEI Integration AFL2-12A-HM65 v1.00 - Manual (Page 42)

AFL2-12A-HM65 Series Panel PC
Page 42
 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,
to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear and anti-static wristband.
4.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the flat bezel panel PC
Step 2: Install an HDD
Step 3: Configure the system
Step 4: Connect peripheral devices to the bottom panel of the flat bezel panel PC
Step 5: Mount the flat bezel panel PC Step 0:
4.4 HDD Installation
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To install the HDD into the AFL2-12A-HM65, please follow the steps below:
Step 1: Remove two (2) retention screws from the HDD cover (Figure 4-1).