IEI Integration AFL2-12A-HM65 v1.00 - Manual (Page 56)

AFL2-12A-HM65 Series Panel PC
Page 56
4.9.2.1 DB-9 Serial Port Connection
Follow the steps below to connect a serial device to the DB-9 connector of the
AFL2-12A-HM65 panel PC.
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
Chapter 2.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the bottom panel. See Figure 4-16.
Figure 4-16: DB-9 Serial Port Connector
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
4.9.2.2 RJ-45 Serial Port Connection
CN Label: COM3
CN Type: RJ-45