2 stand mounting, 3 arm mounting, Figure 4-10: mounting screw location – IEI Integration AFL2-12A-HM65 v1.00 User Manual
Page 51
AFL2-12A-HM65 Series Panel PC
Page 51
4.8.2 Stand Mounting
To mount the AFL2-12A-HM65 using the stand mounting kit, please follow the steps
below.
Step 1:
Locate the screw holes on the rear of the AFL2-12A-HM65. This is where the
bracket will be attached. (Figure 4-10)
Figure 4-10: Mounting screw location
Step 2:
Align the bracket with the screw holes.
Step 3:
To secure the bracket to the AFL2-12A-HM65, insert the retention screws into
the screw holes and tighten them.
Step 0:
4.8.3 Arm Mounting
The AFL2-12A-HM65 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 100mm interface pad. To mount the AFL2-12A-HM65
on an arm, please follow the steps below.
Step 1:
The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.