2 panel mounting, Figure 3-14: iovu-752s panel opening (mm) – IEI Integration IOVU-752S User Manual
Page 32
IOVU-752S Panel PC
Page 25
3.4.2 Panel Mounting
The IOVU-752S can be mounted in a panel.
CAUTION:
When mounting the IOVU-752S, take care to tighten the retention
screws or bolts until fully secure, but do not over tighten. Over
tightening the retention screws or bolts may cause them to become
stripped, rendering them useless.
To mount the IOVU-752S into a panel, please follow the steps below.
Step 1:
Select the position on the panel to mount the IOVU-752S.
Step 2:
Cut out a section from the panel that corresponds to the rear panel dimensions
of the IOVU-752S. Take care that the panel section that is cut out is smaller than
the overall size of the frame that surrounds the IOVU-752S but just large enough
for the rear panel of the IOVU-752S to fit through (see Figure 3-14).
Figure 3-14: IOVU-752S Panel Opening (mm)
Step 3:
Slide the IOVU-752S through the hole until the frame is flush against the panel.