IEI Integration IOVU-752S - Manual (Page 34)

IOVU-752S Panel PC
Page 27
3.4.3 Arm Mounting
The IOVU-752S is VESA (Video Electronics Standards Association) compliant and can be
mounted on an arm with a 75 mm interface pad. To mount the IOVU-752S on an arm,
please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm, please ensure that it is VESA compliant and that
the arm has a 75 mm interface pad. If the mounting arm is not VESA
compliant, it cannot be used to support the IOVU-752S.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the
IOVU-752S onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
IOVU-752S, as shown in Figure 3-17.
Figure 3-17: Arm Mounting Retention Screw Holes