IEI Integration PAC-1000G - Manual (Page 5)

PAC-1000G QIG IEI Technology Corp. Page 5
Figure 9: Three Predrilled Elevated Retention Screw Holes
Step 3: Secure the backplane to the base of the chassis with
nine retention screws.
Figure 10: Insert the Nine Backplane Retention Screws
STEP 5: CPU CARD INSTALLATION
To install the CPU card please follow the instructions below:
Step 1: Remove the slot cover at the back of the chassis.
To do this, remove the slot cover retention screw
at the top of the slot cover.
Figure 11: Remove the Slot Cover Retention Screw
Step 2: Slide a full-size CPU card into the socket on the
backplane reserved for the CPU card. Make sure
the back edge of the CPU card slots into the
corresponding card guide located behind the
cooling fans.
Figure 12: Full-size CPU Card Sockets
Step 3: To secure the CPU card, reinsert the previously
removed slot cover retention screw. Step 0:
STEP 6: PCI/ISA EXPANSION CARD
INSTALLATION
The PAC-1000G supports up to five PCI/ISA expansion
cards. If you wish to install a PCI expansion card or an ISA
expansion card please follow the instructions below:
Step 1: Remove the slot cover at the back of the chassis.
To do this, remove the slot cover retention screw
at the top of the slot cover.
Step 2: Slide the PCI/ISA expansion card into reserved
PCI/ISA socket on the backplane.
Figure 13: PCI and ISA Sockets
Step 3: To secure the PCI/ISA expansion card, reinsert
the previously removed slot cover retention
screw. Step 0:
STEP 7: DISK DRIVES INSTALLATION
The PAC-1000G chassis has the capacity for one
front-accessible 5.25” optical drive, one front accessible 3.5”
FDD and one internal 3.5” HDD.
To install the drives please follow the steps outlined in the
sections below.