IEI Integration PAC-1000G - Manual (Page 8)

PAC-1000G QIG IEI Technology Corp. Page 8
Step 2: Align the screw holes in the other end of the hold-down
clamp with the screw holes on the right side of the
chassis.
Step 3: Reinsert the two previously removed retention screws.
S
TEP 10.2: S HOCK A BSORBER I NSTALLATION
The PAC-1000G chassis comes with three long PCI/ISA card shock
absorbers and three short PCI/ISA card shock absorbers used for
securing PCI/ISA cards from vibration. To install a shock absorber,
please follow the instructions below:
Step 1: Press the rubber of a shock absorber with proper length
against the top of the PCI/ISA card you want to secure,
according to the height of the installed PCI/ISA card.
Step 2: Align the retention screw hole in the shock absorber with
the corresponding retention screw hole in the hold-down
clamp.
Step 3: Insert one retention screw for each shock absorber to
secure it to the hold-down clamp.
Figure 20: Shock Absorber Retention Screw
S TEP 10.3: T OP C OVER R EINSTALLATION
To reinstall the top cover, slide the cover back over the chassis and
reinsert the six previously removed retention screws.
STEP 11: WALL-MOUNT PLATES
INSTALLATION
Two wall-mount plates are shipped with the PAC-1000G chassis.
The wall-mount plates are installed on the sides, at the bottom of the
chassis. Each plate is secured to the chassis by three retention
screws. To install the wall-mount plates, please follow the steps
below:
Step 1: Align the retention screw holes on the side of the
chassis with the retention screws in the
wall-mount plate.
Step 2: Insert three retention screws for each wall-mount
plate. Step 0:
Figure 21: Wall-mount Plate Retention Screws
CHASSIS MAINTENANCE
F AN R EPLACEMENT
NOTE:
Please ensure that the power of the computer is switched off
before you replace a fan.
There is one 8 cm cooling fan inside the PAC-1000G chassis. To
replace a fan, please follow the steps below.
Step 1: Remove the top cover. (Please refer to S TEP 2.1:
R EMOVE THE T OP C OVER )
Step 2: Unplug the power cable that is connected to the fan.
Step 3: Remove the drive bracket. (Please refer to S TEP 8.1:
D RIVE B RACKET R EMOVAL )
Step 4: Remove one side fan bracket retention screw from the
right side of the chassis, two internal fan bracket
retention screws from the base of the chassis and one
other internal fan bracket retention screw from the top of
the fan bracket to remove the fan bracket.
Figure 22: Side Fan Bracket Retention Screw