IEI Integration PAC-1000G - Manual (Page 7)

PAC-1000G QIG IEI Technology Corp. Page 7
Figure 18: Secure a 5.25＂Optical Drive to the 5.25＂Drive Bay
S TEP 7.5: D RIVE B RACKET R EINSTALLATION
After the disk drives have been properly installed into the drive
brackets, reinstall the drive brackets into the chassis. To reinstall the
drive brackets into the chassis please follow the steps below:
Step 1: Remove the two plastic drive bay front covers
from the front of the drive bays by pushing the
plastic front covers out of the chassis.
Figure 19: Drive Bay Front Covers
NOTE:
The 3.5” drive bay front cover does not need to be removed,
if the 3.5” front accessible drive bay is installed with an HDD.
Step 2: Place the drive bracket into the chassis making
sure the front of the drives are facing out of the
chassis and the 4-pin drive power connector and
the IDE/SATA interface connector are all facing
the rear of the chassis.
Step 3: Secure the drive bracket into the chassis by
reinserting the five previously removed retention
screws, one internal drive bracket retention screw
and four drive bracket retention screws from the
right side of the chassis. Step 0:
STEP 8: CABLING
The PAC-1000G has the following components accessible
at the front:
o 1 x Power LED
o 1 x HDD LED
o 1 x Power switch
o 1 x Reset button
These components are all connected to the CPU card with
cables. To correctly connect these cables, please refer to
the technical documentation that came with your CPU card.
The connectors that are provided with the chassis are listed
below.
No. Name
1
Power LED cable
1
Reset Switch cable
1
HDD LED cable
1
Power switch cable
Table 3: Chassis Connectors
STEP 9: PSU CABLE AND INTERFACE
CABLE CONNECTIONS
To connect the power and ribbon cables please follow the
instructions below:
Step 1: Connect the PSU cables from the PSUs to the
backplane, full-size CPU card, HDD, FDD,
cooling fans and optical drives power connector.
Step 2: The drive interface connectors must be
connected to the CPU card. Step 0:
STEP 10: HOLD-DOWN CLAMP, SHOCK
ABSORBER AND TOP COVER
REINSTALLATION
After you have completed the above procedures, the hold-down
clamp and cover can be reinstalled.
S TEP 10.1: H OLD -D OWN C LAMP R EINSTALLATION
To reinstall the hold-down clamp, please follow the instructions
below:
Step 1: Slide the two pillars on the left side of the chassis into
the two holes in one end of the hold-down clamp.