IEI Integration PAC-1000G User Manual
Page 9
PAC-1000G QIG IEI Technology Corp. Page 9
Figure 23: Three Internal Fan Bracket Retention Screws
Step 5:
Remove the drive bracket. (Please refer to S
TEP
8.1:
D
RIVE
B
RACKET
R
EMOVAL
)
Step 6:
Remove the five front panel retention screws to remove
the front panel.
Figure 24: Five Front Panel Retention Screws
Step 7:
Remove the four front panel metal plate retention
screws to remove the metal front panel plate.
Figure 25: Four Metal Front Panel Plate Retention Screws
Figure 26: Remove the Metal Front Panel Plate
Step 8:
Remove the fan filter cover and the fan filter pad inside.
(Please refer to Step 1 of F
AN
F
ILTER
R
EPLACEMENT
section)
Step 9:
Press the three fan clips, one on the top of the fan and
two at the bottom of the fan, and push the fan outwards.
Figure 27: One Fan Clip on the Top of the Fan
Figure 28: Two Fan Clips at the bottom of the Fan
Step 10:
Install a new fan.
Step 11:
Reinstall the fan filter pad and fan filter cover.
Step 12:
Reinstall the front panel metal plate with the four
previously removed front panel metal plate retention
screws.
Step 13:
Reinstall the front panel to the chassis with the five
previously removed retention screws.