Ramsey Winch H-930R DOW-LOK w/Air Shifter for Szummar - Manual (Page 12)

6. Remove gear housing cover (item #14) from gear hous-
ing (item #19) by removing (8) capscrews (item #48).
Thread (2) of the capscrews into the two tapped holes of
cover and tighten until the cover comes loose from the
gear housing.
Remove the cover gasket (item #86) and pull shaft (item
#29), with gear attached, from gear housing.
7. Check for signs of wear on gear teeth. If necessary, remove gear with hub attached from shaft by sliding gear to
end of shaft. Disassemble the gear from the hub by remov-
ing (10) capscrews (item #54) and washers (item #74).
Replace gear, hub, shaft, or keys as needed.
8. To replace gear and hub onto shaft:
a. Tap keys (item #25) into short keyways of drum shaft
(item #29).
b. Press shaft (item #29) and keys through gear hub
(item #22) until end of keys on long end of shaft are
flush with hub.
c. Align holes in gear (item #17) with holes in gear hub (item #22). Press gear into hub. Be sure gear is seat-
ed all the way on the hub. Secure gear to hub using (10) capscrews (item #46) with lockwashers (item
#64. Tighten to 121 ft-lbs. (164 Nm) torque each.
10
14
48
86
29
19