Ramsey Winch H-930R DOW-LOK w/Air Shifter for Szummar User Manual
Page 13
9. Check gear housing bushing (item #8) and o-ring (item
#91) for signs of wear. Replace if necessary by pressing old
bushing from gear housing. Press new bushing into place
and insert new o-ring into groove inside of bushing.
10. Check drum bushings (items #41 and #42) for
signs of wear. Replace if necessary by pressing
old bushings from drum (item #1). Press bush-
ing (item #41) into bore in drum until its flange
is seated against bottom of counterbore. Press
bushing (item #42) into opposite bore on drum
until end of bushing extends .5” from end of
drum.
11. Check end bearing bushing (item #42) for signs of
wear. If necessary, remove old bushing and press
new bushing into place.
12. Check end bearing cover bushing (item #8) and o-
ring (item #91) for signs of wear. Replace if neces-
sary by pressing old bushing from gear housing.
Press new bushing into place and insert new o-ring
into groove inside of bushing.
91
19
8
11