Ramsey Winch H-930R DOW-LOK w/Air Shifter for Szummar User Manual
Page 14
13. Apply grease to end of shaft, opposite gear. Apply grease
to bushing in gear housing (item #19). Place greased
end of shaft through bushing in gear housing. Place gas-
ket (item #86) onto gear housing cover (item #19).
Apply grease to gear end of shaft and cover bushing.
Place cover onto shaft and secure to housing with (8)
capscrews (item #48). Tighten capscrews to 39 ft-lbs.
(52 Nm) each.
14. Press bearing (item #38) onto worm (item
#34). NOTE: Be sure that thick shoulder of bear-
ing’s outer race (side with manufacturer’s name
and part number) is out, away from worm
threads. Press bearing and worm into gear hous-
ing.
Slip gasket (item #84) onto brake housing (item
#18). Use (6) capscrews (item #61) to secure
brake housing to gear housing. Tighten cap-
screws to 45 ft-lbs. (61 Nm) each.
Place key (item #24) into keyway of worm (item
#34). Refer to Reassembling and Checking the
Brake, page 6 .
15. Press bearing (item #38) onto worm and into
housing. NOTE: Be sure that thick shoulder of
bearing’s outer race (side with manufacturer’s
name and part number) is out, away from worm
threads. Attach adapter (item #3) to gear hous-
ing using (6) capscrews (item #61). Tighten
capscrews to 45 ft-lbs. (61 Nm) each.
Insert key (item #23) into keyway of worm
shaft. Slide coupling (item #11) over end of
worm shaft. Attach adapter plate (item #27) to
adapter using (8) capscrews (item #58).
Tighten capscrews to 21 ft-lbs (28 Nm) each.
Place motor shaft, with key in keyway, into cou-
pling. Secure motor to adapter, using (2) cap-
screws (item #62). Tighten capscrews to 102
ft-lbs. (138 Nm) each.
14
48
86
29
19
84
38
61
24
34
18
12
84
3
100
61
11
58
104
16
109
62
27
90
38
23