Progressive International Electronics PIcon Console - Manual (Page 25)

PIcon Program & Report
Rev 2.0 June 2006 Page 21
Mode 2 — Product Information (Manager only)
In this mode, Product Name, Cash PPU and Credit PPU for each product at the site are
programmed. To enter this mode from the M 0, mode number prompt, press <2> on the
numeric keypad and then press <ENTER>. You are now in Mode 2.
Product Name — The display now prompts for information about product #1. To assign
a product name such as UL REG or DIESEL to this product, press the <GRADE> key
until the desired product name is presented in the display. If you wish to just view the
product name already assigned, press the <SELECT> key and the name will appear in
the display.
Cash PPU — To set the Cash PPU for a product, enter the desired PPU on the numeric
keypad and press the <CASH PAID> key. The three decimal places are assumed.
Credit PPU — To set the Credit PPU for a product, enter the desired PPU on the
numeric keypad and press the <CREDIT PAID> key. The three decimal places are
assumed.
As the Cash and Credit PPUs are entered, numeric key errors may be erased by pressing
the <CLEAR> key and reentering the data. Also, Cash and Credit PPUs may be viewed
by pressing the <CASH PAID> or <CREDIT PAID> key. The value will appear in the
display. Note: Both cash and credit prices must be programmed for each product —
even if prices are the same.
To proceed to the next product number to be programmed, press the <ENTER> key. Follow
this procedure for each product type at the site.