Progressive International Electronics PIcon Console - Manual (Page 26)

PIcon Program & Report
Rev 2.0 June 2006 Page 22
Exit Mode 2 by pressing the <MNGR> key. The PIcon display returns to M 0, the mode
entry prompt. To exit programming mode completely and return to operator mode, press the
<MNGR> key again.
Mode 3 — Beeper Settings (Manager only)
Mode 3 is used to program single or continuous beeps for Handle, Collect and Drive-Away.
(Note: The console defaults to a single beep unless set otherwise.) To enter Mode 3 from M
0, the mode number prompt, enter <3> on the numeric keypad and press <ENTER>.
Handle/Call for Service — The display first will prompt for selection of the style of
beep associated with a Handle/Call for Service. To change the style of beep, press the
<SELECT> key and toggle between single and continuous. To proceed to the next
option setting, press <ENTER>.
Collect — The display now prompts for selection of the style of beep associated with a
Collect condition. To change the style of beep, press the <SELECT> key and toggle
between single and continuous. To proceed to the next option setting, press the
<ENTER> key.
Drive-Away — The display now prompts for selection of the style of beep associated
with a Drive-Away condition. To change the style of beep, press the <SELECT> key
and toggle between single and continuous.
Exit Mode 3 by pressing the <MNGR> key. M 0, the mode entry prompt, will appear on the
display. To exit programming mode completely and return to operator mode, press the
<MNGR> key again.