Progressive International Electronics PIcon II Console - Manual (Page 30)

PIcon II Reports
Rev 1.0 January 2014 25
PRN 11 — Shift 3 Totals By Pump (for 3 shifts previous)
PRN 12 — Print Program Settings
PRN 13 — Print Error Queue
PRN 14 — Program Print Header
Select the report number of the report to be printed and enter it on the PIcon II keypad, then
press <ENTER>. The chosen report will be printed and the display will return to PRN 0.
To exit OPR 2/MGR 3, press the <MANAGER> key. MGR 0, the mode entry prompt, will
appear on the display. To return to operator mode, press the <MANAGER> key again.
PRN 14 – Print Header – Initiate programming of Print Header by pressing <14> from
the opening print screen, PRN 0. The display will show the beginning information for the
print header. If the header has not already been programmed or has been cleared, the
cursor will prompt for the first character entry. Refer to Table: Print Header Character
Codes at the end of this section for a numeric code which represents the characters
available for your use on the printer header. Determine the character you wish to place
in the first position of the header and look up the numeric code. Enter this numeric code
on the keypad and press <ENTER>. The character will appear on the display, and has
been saved in memory. For each subsequent character, follow the same sequence.
There are two special numeric codes for the header: <10> indicates a new line in the
header; <01> is the code for end of header. Enter the new line code at the point where
the printer should cease printing on the current line and go to the beginning of the next
line. The end of header code is entered after the entire header is entered and will tell the
PIcon II that no more characters are needed in the header.
Special editing features are available for use under Print Header:
<ENTER> without entering a numeric code — Display cursor will increment to next
character in the header.
<SELECT> without entering a numeric code — Display cursor will go back one
character in the header.
<CHANGE> without entering a numeric code — Entire print header will be cleared.
<PRINT> without entering a numeric code — Printer will print the header that is
programmed.
<MANAGER> — Exit Print Header programming.
To exit Mode MGR 3, press the <MANAGER> key. MGR 0, the mode entry prompt, will
appear on the display. To return to operator mode, press the <MANAGER> key again.