Maple Systems HMI5000P - Manual (Page 12)

12 HMI5000P Installation Guide
1010-1014 Rev 01 www.maplesystems.com
Mount the HMI to the Panel
Figure 5: Installing Screw Clamps to the HMI
Note: The clamps for your model may be slightly different than shown
here, but essentially work in the same way.
STEPS:
1. Prepare the clamps for the HMI by inserting the screws into the
clamp as shown above. Position the screws so that the ends don’t
protrude through the clamp’s hole.
2. Set the HMI in the panel cutout and hold it in place until all
clamps are in position.
3. Tighten the screw clamps in an even pattern until all are
uniformly snug.
Caution: Do not over-tighten the screws beyond snugness or
you may damage the housing or warp the overlay.