Maple Systems HMI5000P - Manual (Page 4)

4 HMI5000P Installation Guide
1010-1014 Rev 01 www.maplesystems.com
and immunity requirements as set forth in the EN55022 (Emissions) and
EN55024 (Immunity) standards. The products are designed to withstand
electrical noise in harsh industrial environments. They also conform to
requirements that limit electrical emissions. However, this does not
guarantee that the products will be totally immune from possible
malfunction in cases where severe electrical noise occurs. Therefore, we
strongly recommend that you follow the guidelines outlined in this guide
for proper wire routing and grounding to insure the proper operation of
your graphic HMI.
NEMA Rating
The HMI5000P Series is rated for NEMA 4 (indoor) or IP65/IP66
installations. This means that when the HMI is properly mounted to a
NEMA 4 panel or other NEMA 4 rated enclosure, the front enclosure of
the HMI will provide protection to the inside of the panel from splashing
water, wind-blown dust, rain, or hose-directed water. The HMI must be
installed according to the instructions in this manual to be properly
sealed.
Environmental Considerations
The HMI5000P Series is designed to operate in temperatures from 0° to
50°C (32° to 122°F). It is intended for indoor installations and may not
be suitable for use in certain outdoor applications. Avoid installing the
HMI5000P Series touchscreens in environments with severe mechanical
vibration or shocks. Do not install the HMI in enclosures with rapid
temperature variations or high humidity. Either case will cause
condensation of water inside the device and eventual damage to the HMI.
Safety Precautions
Please observe the following precautions when installing the HMI.
Failure to comply with these restrictions could result in loss of life,
serious personal injury, or equipment damage.