Maple Systems HMI5000P - Manual (Page 13)

13 HMI5000P Installation Guide
1010-1014 Rev 01 www.maplesystems.com
REINSTALLATION: If, at any time, you are required to reinstall an
HMI into a panel, be aware that the gasket will take a ‘set’ to the panel
and may no longer provide an adequate NEMA 4 seal Therefore, for best
results, we recommend that you replace the gasket if reinstallation is
required.
Configuration Wiring
To configure the HMI using the EZwarePlus software, you will need the
correct configuration cable for your HMI. Please refer to the following
table for configuration (download) cable requirements.
HMI Model
Ethernet
Configuration
Cable (Crossover)
P/N 7431-0104
USB
Configuration
Cable
P/N 7431-0115
HMI5070P, HMI5121P, HMI5150P X X
Ethernet
If using a switch or router between the PC and the HMI, use a straight-
through or crossover cable as required by the switch or router.
USB
A USB driver (included with the EZwarePlus software) must be installed
when downloading from the PC to the HMI via a USB connection. To
install the USB driver, please refer to the help file ‘How Do I’ section in
EZwarePlus for detailed step-by-step instructions.
Note: When connecting two powered devices, a difference in potential
can exist between the ground reference on each device. If there is a
difference in ground potential (voltage), making a connection via a USB
cable can complete a ground loop that may damage the HMI and PC. We
recommend using the Maple Systems USB Configuration Cable (P/N
7431-0115) to connect the HMI to the PC. The shield is not connected
between the two ends of the cable, which will prevent a potentially
damaging ground loop from occurring between the devices. Please refer
to page 5 for proper wiring instructions.