Maple Systems HMI5000P User Manual
Page 14
14
HMI5000P Installation Guide
1010-1014 Rev 01 www.maplesystems.com
Maintenance
Figure 6: DIP switch positions (power must be cycled on the HMI to enable the DIP
switch mode).
SW1
SW2
SW3
SW4
Mode
ON
OFF
OFF
OFF
Calibration mode
OFF
ON
OFF
OFF
Hide System Toolbar
OFF
OFF
ON
OFF
Force into Boot Loader mode
OFF
OFF
OFF
ON
Reserved
OFF
OFF
OFF
OFF
Normal operation
Touchscreen Calibration mode: This mode allows you to recalibrate
the touchscreen.
Hide System Toolbar: Hides the arrow in the bottom-right corner of the
screen that accesses the System Toolbar (same as “Hide System Toolbar”
in System Parameters and LB9020).
Boot Loader mode: This mode forces the HMI to not execute the
project. This mode is used when replacing or reinstalling the operating
system. Contact Maple Systems for more information.
Fusing Requirements
If the display does not come on within two seconds of power up, remove
power. An internal fuse will prevent damage if the polarity of the DC
power is incorrect. Check wiring to insure proper connections and try to
power up again.
Serial Port Connections
The diagram below indicates the proper pin connections for the serial
ports of the HMI5000P Series.