Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" User Manual
Page 34
36
Eng
lis
h
Installation
3
Slowly peel the protective sheet off of the GP unit's screen.
Note : Peeling off the protective sheet with excessive force may peel off the
film of the touch panel.
4
When the GP unit is shipped from the factory, installation brackets
are fixed to its top surface and bottom surface.
These installation brackets are fixed in positions that do not match
the resin boss type, so follow the procedure below to change the
positions in which the installation brackets are attached.
5
Orient the GP unit so that its screen faces down, and then place the
GP unit on a clean and level surface.
6
Use a Phillips head screwdriver to remove the two installation
screws fixing the one installation bracket in place on the top surface
of the GP unit. In the same manner, remove the one installation
bracket from the bottom surface.
7
Attach the installation brackets to the top and bottom surfaces of
the GP unit or to the sides of the GP unit. In each case, attach the
surface of the installation bracket that has six open holes to the GP
unit as shown. Use a Phillips head screwdriver to fix in place two
installation screws per installation bracket. The tightening torque is
0.8 N•m (7.1 lb-in).
1) Use two installation screws to fix the bracket in place. (Use
the two inner holes.)