Watlow ANASCAN - Manual (Page 23)

START UP
ANASCAN User’s Guide 15
Disk file errors
While reading in the system files, several reading errors can occur. The
system files are SYSSU.DAT, INSTAL.DAT, and PLOT.DAT.
ANASCAN cannot run without these files.
Message Cause Solution
ERROR WHILE
READING DATA
FILE: xxxxxxxI
FILE NOT FOUND The system file does
not exist on the indi-
cated disk and direc-
tory path. The INSTAL.DAT file should be on the
default drive and directory. The other sys-
tem files should be on the data file drive
and directory path as set in the installation
program. If these files are not in the right
directories, copy the system files from the
backup disks to the appropriate directories.
ERROR WHILE
READING DATA
FILE:xxxxxxx
Drive not ready
Read fault
General failure
or
Access failure There is a disk drive
hardware access fail-
ure. Run CHKDSK or other diagnostic pro-
gram in order to verify that there is no disk
drive error.
For a floppy drive: make sure that there is
a disk in the right drive and that the drive
door is closed.
ERROR WHILE
READING DATA
FILE:xxxxxxx
Path not valid
or
Invalid disk drive The data disk path
that you set in the
SCANINST installa-
tion program is not
valid. Run SCANINST and verify that the drive
and directory path exist and are valid.
Don’t forget to verify that “\” is at the end
of the path entry.
INVALID DATA
FOUND ON DATA
FILE:xxxxxxx There is corrupted or
invalid data in the
disk file. Copy the original data file sent with
ANASCAN from the backup disks.