Annunciator, Auto-tune set point, Ramping function for channel – Watlow Series 998 User Manual
Page 63: Anun] [atsp, Rp`a, Setup-global, Ramping function for channel a
WATLOW Series 998 User’s Manual
4.35
Setup Menus, Chapter 4
Annunciator
Select whether alarm messages will flash in the lower display.
[Anun] This prompt always appears.
Default
↓
[``On]
[`OFF]
[Anun]
[Anun]
Auto-tune Set Point
Select the percentage at which the controller will auto-tune the cur-
rent control set point.
[AtSP] This prompt always appears.
Default
↓
[``50]
…
[``90]
…
[`150]
%
[AtSP]
[AtSP]
[AtSP]
Ramping Function for Channel A
Select when channel A will enter ramping mode.
• [Strt] Activates ramping on power up only.
• [StPt] Activates ramping on power up and any set point change.
[rP`A] This prompt always appears.
Default
↓
[`OFF]
[Strt]
[StPt]
[rP`A]
[rP`A]
[rP`A]
[Anun]
[AtSP]
Setup-Global
[rP`A]
NOTE:
Lower display alter-
nately flashes
{`rp`}
and lower
display value when
ramping is in
process.