AMT Datasouth 7200 - Manual (Page 21)

7200
2-2 Operation Manual
2.1 Connecting the ATB Printer
This section explains how to connect the ATB printer to the power supply and the terminal.
2.1.1 Connecting to a Wall Receptacle
A. Check that the power switch on the
ATB printer is turned off.
B. Plug the power cable into the ATB
printer. Then, plug the other end of the
power cable into a wall receptacle.
Note!
Only use the supplied power cable.
Ensure that the power cord complies
with all local ordinances.
Ferrite Core
IMPORTANT...
The
Ferrite Core must be attached to the AC Power Cord before the printer is connected to the
wall receptacle. Failure to attach the Ferrite Core to the AC Power Cord may cause non-compli-
ance to:
FCC Regulations for Class A computing device Canadian ICES-003
EN55022-1 Class A Limits EN50082-1
EN61000-3-2 EN61000-3-3