AMT Datasouth 7200 - Manual (Page 23)

7200
2-4 Operation Manual
2.2 Turning the Power On and Off
After the ATB printer has been successfully installed and connected, turn on the power.
Note!
Turn on the terminal before turning on the ATB printer. Reverse the sequence
when turning off the power.
LCD Test
or
TICKETING
CHECK-IN
S7200/08.30
Mecha.Type: D
S7200/PC94.03.08
This indicates the online
status.
(Ticketing is enabled.)
The ATB printer is
checking itself.
ROM Version
(The display on the left is an
example.)
Available Type
(The display on the left is an
example.)
Modes
(The display on the left is an
example.)
(OFF)
ONLINE
ONLINE
(ON)
Turn the power switch on.
The LCD panel displays the following three
indicators in turn for specified intervals (a
few seconds). Then, the ATB printer is set
online.
When the power is turned on, the four LEDs
are turned on as part of the self test routine.
The above is only an example. The actual displayed ROM value and available type
may be different from this example.