AMT Datasouth 7200 - Manual (Page 61)

7200
4-12 Operation Manual
4.2 Error Messages
When an error has occurred in the ATB printer, an error message is displayed on the LCD
panel. The error messages are listed in the table below.
Error Message Error State Recovery Procedure
WARNING: Indicates a relatively minor error, ex.
when consumption articles (documents,
etc.) has run short (paper-out), when the
operator has made a mistake, etc.
Open the cover, take necessary actions for
recovery, and close the cover.
If the error continues, contact a service
technician.
PAPER JAM: Indicates an error caused by the paper
jam. The block where the paper jam has
occurred is displayed.
Open the cover, remove the jammed
coupon, and close the cover.
COM.ERROR: Indicates an error in communication with
the terminal. Verify communication parameters. If the
error continues, contact a service
technician.
ENCODING
ERROR: Indicates an error during magstripe
encoding.
The error coupon is automatically ejected
and voided.
Press the RESET key.
If the error continues, contact a service
technician.
MAGNETIC
ERROR: Indicates an error during magstripe
decoding.
Press the RESET key.
If the error continues, contact a service
technician.
SYSTEM ERROR: Indicates an error that seldom occurs
under ordinary circumstances. Power the printer off and on. If the error
continues, contact a service technician.
OTHERS: Indicates other errors such as AEA
programming errors, etc.Indicates a
relatively minor error. For example, end
of expendables (coupons) or operator
errors.
Power the printer off and on. If the error
continues, contact a service technician.