Yokogawa FieldMate - Manual (Page 23)

<3 PRM Synchronization Tool start>
3-14
IM 01R01A20-01E 8th Edition : May 31, 2013-00
 Memo
You can include a maximum of 1000 memos during data transfer. Both approved and
unapproved memos will be transferred from PRM to FieldMate. Memos that are transferred from
FieldMate to PRM will be created as unapproved memos.
030309E.ai
Figure3-9 Advanced Configurations dialog box - Memo tab
To select memo:
1. Under Data Options, select the [Memo] check box. A check mark appears and the options in
the Memo tab are enabled.
The options in the tabs are only enabled after you select the corresponding Data Options
check box.
2. Enter the number of memos to be included from 1 to 1000.
3. Click [OK] to apply and save the settings.
• Click [Cancel] to revert to the previous configuration settings.
• Click [Default] to use the Advanced configurations default settings.
 Documents
Documents for all devices can be included in the data transfer. FieldMate can support an
unlimited number of documents.
To select documents, you can follow these steps:
1. Under Data Options, select the [Documents] check box. A check mark appears and all
documents are included in the transfer.
2. Click [OK] to apply and save the settings.
• Click [Cancel] to revert to the previous configuration settings.
• Click [Default] to use the Advanced configurations default settings.