Yokogawa Removable Chassis DX1000N - Manual (Page 182)

3-65
Commands
IM 04L41B01-17E
1
2
3
4
5
6
App
Index
3.10 Output Commands (Special
Response Commands)
*I Outputs instrument information
Syntax *I<terminator>
Description This command sends the maker, model, serial
number, and firmware version in a comma-
separated ASCII string with a terminator at the
end.
Example YOKOGAWA,DX1000,99AA0123,F1.01
3.11 Maintenance and Test
Commands (Available when
using the maintenance/
test server function via
Ethernet)
close Closes another device’s
connection
Syntax close,p1,p2:p3<terminator>
p1 Port on the DX side (1 to 65535)
p2 IP address on the PC side
(0.0.0.0 to 255.255.255.255)
p3 Port on the PC side (0 to 65535)
Example close,34159,192.168.111.24:1054
E0
Description You cannot use this command to disconnect a
server port. You cannot use this command to
disconnect from the DX that you are operating.
Use the quit command instead.
con Outputs connection information
Syntax con<terminator>
Example
con
EA
00/00/00 12:34:56
Active connections
Proto Local Address Foreign Address State
TCP 192.168.111. 24:34159 192.168.111. 24:1053 ESTABLISHED
TCP 0. 0. 0. 0:34155 0. 0. 0. 0:
0 LISTEN
TCP 0. 0. 0. 0:34159 0. 0. 0. 0: 0 LISTEN
TCP 0. 0. 0. 0:34150 0. 0. 0. 0: 0 LISTEN
EN
TCP
Protocol used.
Local Address
DX socket address.
Displays “IP address:port number.”
Foreign Address
Destination socket address
Displays “IP address:port number.”
State
Connection state.
ESTABLISHED
Connection established.
eth Outputs Ethernet statistics
Syntax eth<terminator>
Example
eth
EA
00/00/00 12:34:56
3.10 Output Commands (Special Response Commands) / 3.11 Maintenance and Test Commands