Yokogawa Value Series FX1000 - Manual (Page 13)

2-4
IM 04L21B01-63EN
Contents of the Basic Information Tab
Item Description
File Name The file name. (If the file name is long, the portion that does not fit within the dialog box is not
displayed.)
Device Type FX1000
Serial No. The device’s serial number.
File Message The file message (up to 50 characters; specified as the file header).
Time Correction Whether or not the time was changed while data was being acquired (done/none).
Start Start Time The time when data acquisition started (yyyy/mm/dd hh:mm:ss.mmm).
Started by The name of the user who started data acquisition (up to 20 characters).
Starting Cond. The condition under which data acquisition started (Manual/Restart after Black Out/Auto/Triggered
Restart/Over Write/Unknown).
Stop Stop Time The time when data acquisition stopped (yyyy/mm/dd hh:mm:ss.mmm).
Stopped by The name of the user who stopped data acquisition (up to 20 characters).
Dividing Cond. The condition under which data acquisition stopped (Manual/Black Out/Auto/Data Count/
Interrupted/Unknown).
Meas Ch. The number of measurement channels.
Math Ch. The number of math channels.
Ext. Ch. This is not applied to the FX data.
Data Count The number of data points.
Sampling Int. The sampling interval, in seconds.
Trigger Time The trigger time (yyyy/mm/dd hh:mm:ss.mmm).
Trigger No. The trigger position (from 0).
Damage Check The status of the data file (damaged/not damaged).
Comment You can insert a print comment of up to 127 characters in length.
Contents of the Batch Information Tab
Item Description
Batch Name The batch name
(up to 32 characters).
Lot No. The lot number
(range: 0 to 99999999).
Title 1 to Title 24 1 The batch text title
(up to 20 characters).
Description The batch text description
(up to 30 characters).
1 You can use up to eight of these on the FX.
Contents of the Batch Comment Tab
Item Description
Comment 1 to Comment 3 The time when the comment was made (yyyy/mm/dd hh:mm:ss.mmm).
The comment itself
The user who made the comment (up to 20 characters).
2.1 Starting and Exiting the Data Viewer