Yokogawa DAQWORX - Manual (Page 42)

3-6 IM WX201-01E
3.3 Settngs n the Channel Setup Screens
Procedure
You can edit display settings by following the indications in the figure below.
Turn waveforms ON/OFF
Select channels
Select channels
Turns the Y-axis ON/OFF
when in multi-zone display
Select Y-axis type (linear or logarithmic)
Select a scale value display
format (floating point or exponeial)
Specify a waveform
display zone
Channel display
color
Turn trip point
ON/OF
Switch the displayed group
Display channel details.
Set linked groups (OFF, 1, 2, 3, 4)
Swich between the display channel settings screen
and waveform display screen
Add/delete/move forward/backward groups
Delete channels or move them (up and down)
Switch between the channel Information and
channel display configure screens
Select/clear all channels
Explanaton
Dsplay/Hde Channels
By selecting and clearing the check buttons in the No. column on the channel display
configure screen, you can select whether to display those channels”data in the Trend
display screen.
Channel (Tag Number and Tag Comment): Can be selected/deselected for
dsplay.
The Channel column displays the channel, tag number, and tag comment.
Dsplay/Hde Y-Axs and Type
By selecting and clearing the check buttons in the Y-axis column, you can select
whether to display the Y-axes of the corresponding channels in the Trend display
screen. This setting is only valid if multiple zones are specified in the Trend display
screen.