Yokogawa Standalone MW100 - Manual (Page 14)

14
IM MW100-0E
Connecting to a Network
Connecting an Ethernet Cable to the Main Module
Connect the Ethernet cable to the Ethernet port on the main module. Use a UTP (category
5 or higher) or STP Ethernet cable.
RJ-45 modular jack
Ethernet port
Ethernet cable
Checking the Communication Status
You can check the status on the two LEDs at the upper-right and lower-right of the
Ethernet port.
ETHERNET
LINK LED
Illuminates in orange when the link between
the MW100 and the connected device is
established and communication is mutually
possible.
TX LED
Blinks in green when packet transmission is
being carried out normally.
Connection to the PC
Make the connection via a hub. For a one-to-one connection with a PC, make the
connection as shown in the figure below. In the same manner, you can connect multiple
MW100 Data Acquisition Units to a single PC.
MW100
MW100 Data Acquisition Unit
Ethernet port
Hub
PC
Ethernet cable