Yokogawa Standalone MW100 - Manual (Page 17)

17
IM MW100-0E
Entering Settings on the MW100 Using a Browser
MW100 System Settings
Display of Module Information and Reconfiguration
1. From the browser top screen, click System Setting > Module Information.
The module information screen is displayed.
2 . If the Configured Module and Attached Module displays
are different, click here.
System reconfiguration is executed.
The Configured Module and Attached Module displays
become the same.
If the attached module does not appear, turn OFF the
power and check that the module is attached correctly.
Setting the Date and Time
. After choosing System Setting in step 2, click Date and Time Setting.
The date/time setting screen appears.
4. Change the date and time setting.
The following is an example.
Date: October 25, 2007
Time: 10:25:00
Time zone: 9:00.
Enter the last two digits of the Western
calendar.
This differs depending on the country
and region.
For Japan, it is 9:00.
5 . Click here.
The date and time settings are changed.