Yokogawa DAQWORX - Manual (Page 13)

2-3 IM WX1-03E
1
2
3
Index
Operat
ng Procedure
WT Settngs
Procedure
1. Click the WT Setting tab or choose Vew > WT Settng from the menu bar.
The WT Setting tab is displayed.
Click to display the Input
Address dialog box
Click to display a list
Only the active COM ports
(specified in serial port settings)
are displayed
2. Enter the communication method and address.
Communcaton type : Select the port to be used for the connection. Only
the numbered COM ports turned ON in the serial
setting tab are displayed.
For GP-IB
Click a cell in the Address column to open the dialog box in the figure below.
Enter the GP-IB address.
For Ethernet (ETHER)
Click Address to display the following dialog box.
Enter the IP address or host name, user name (only WT1600), and password
(only WT1600).
For Seral Ports Set to COM1–COM9 (RS-232 Ports)
An address is not entered.
Address : Only needed if the communication type is GP-IB.
2.2 Enterng Envronment Settngs