Yokogawa DAQWORX - Manual (Page 7)

1-1 IM WX1-03E
1
2
3
Index
Overv
ew
Chapter 1 Overvew
1.1 Overvew of GateWT Functons
GateWT is a software program that acquires data from WT series instruments and
transfers it to DAQLOGGER or Remote Monitor. Using GateWT allows you to monitor
data on DAQLOGGER or Remote Monitor that is measured on WT series instruments.
Yokogawa’s DAQLOGGER is a software program that allows users to open a connection
from their PC to various kinds of Yokogawa recorders (the mR, VR, DARWIN, DX, MV,
and CX) and perform data logging and monitoring.
Yokogawa’s Remote Monitor is a software program that enables monitoring of data
logged by recorders or data logging software.
Note
When connecting the GateWT and WT1600 and acquiring data, you must set the WT1600’s
measurement range to Fixed Range since data communication is not possible if it is set to Auto
Range.
Features
• Runs as a Windows application.
• Compatible with the following instruments: WT110, WT110E, WT130, WT200, WT210,
WT230, WT1010, WT1030, WT2010, WT2030, WT1030M, WT1600, WT1800 and
WT500.
• Up to 16 units of the WT100, WT200, WT1000, WT2000, WT1600, WT1800 or WT500
can be linked.
• Measurement can be performed at intervals of up to 0.5 seconds*.
* However, DAQLOGGER’s shortest interval is 1 second. Also, the maximum speed of 0.5
seconds may not be attainable depending on the amount of data being read, the response time
of the device, and the communication speed.