AT&T 2812B - Manual (Page 15)

12
Telephone operation
Basic operation
Last number redial
Press
REDIAL/
PAUSE
to display the most recently
dialed numbers (up to 32 digits). Press
CID/-VOLUME
,
DIR /VOLUME+
or REDIAL
/PAUSE
repeatedly to view
up to five recently called numbers. The handset
beeps twice at the beginning or end of the list. Press
OFF/
CLEAR
to exit. Press PHONE/
FLASH
or
SPEAKER to redial any displayed number. Or press
PHONE/
FLASH
or SPEAKER then REDIAL/
PAUSE
to dial the most recently dialed number (up to 32
digits).
Press
MUTE
/DELETE to delete the displayed number
from the redial memory.
Temporary ring silencing
Press
OFF/
CLEAR
or MUTE/
DELETE
while the telephone
is ringing to silence the ringer temporarily. This
will silence the ringer without disconnecting the
call. The next incoming call will ring normally.
NOTE: If there is more than one handset in use, all hand-
sets ring with an incoming call except those with the vol-
ume turned off. Press
OFF/
CLEAR
or MUTE/
DELETE
on
one handset will only silence the ringer of that particular
handset but the other handset(s) will continue to ring.
Handset locator
If the handsets are misplaced, press
HANDSET
LOCATOR on the telephone base. The handsets
will play a paging tone for 60 seconds to help you
locate them. To stop the paging tone, press PHONE
/FLASH
,
SPEAKER, or any dial pad key (0-9, *, or #) on
the handsets, or press HANDSET LOCATOR on
the telephone base.
NOTES:
1. If the handset ringer is set to off (0), that handset will not generate
paging tone.
2. During a page, if you press During a page, if you press OFF/
CLEAR
or MUTE/
DELETE
on the
handset (see this page above), the ringer of that handset will be
silenced, but it will not cancel the page.
INT
REDIAL
555-1234
RINGER MUTE