Displaying the ipv6 route table – Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide User Manual

Page 199

Advertising
background image

The interface parameter restricts the display to the entries for the specified router interface. For this
parameter, you can specify the Ethernet or VE keywords. If you specify an Ethernet interface, also
specify the port number associated with the interface. If you specify a VE interface, also specify the VE
number.

This display shows the following information.

IPv6 neighbor information fields

TABLE 36

Field

Description

Total number of
neighbor entries

The total number of entries in the IPv6 neighbor table.

IPv6 Address

The 128-bit IPv6 address of the neighbor.

Link-Layer
Address

The 48-bit interface ID of the neighbor.

State

The current state of the neighbor. Possible states are as follows:

• INCOMPLETE - Address resolution of the entry is being performed.
• *REACH - The static forward path to the neighbor is functioning properly.
• REACH - The forward path to the neighbor is functioning properly.
• STALE - This entry has remained unused for the maximum interval. While stale, no action

takes place until a packet is sent.

• DELAY - This entry has remained unused for the maximum interval, and a packet was sent

before another interval elapsed.

• PROBE - Neighbor solicitation are transmitted until a reachability confirmation is received.

Age

The number of seconds the entry has remained unused. If this value remains unused for the
number of seconds specified by the ipv6 nd reachable-time command (the default is 30
seconds), the entry is removed from the table.

Port

The physical port on which the entry was learned.

vlan

The VLAN on which the entry was learned.

IsR

Determines if the neighbor is a router or host:

0 - Indicates that the neighbor is a host.

1 - Indicates that the neighbor is a router.

Displaying the IPv6 route table

To display the IPv6 route table, enter the following command at any CLI level.

device#show ipv6 route

IPv6 Routing Table - 7 entries:

Type Codes: C - Connected, S - Static, R - RIP, O - OSPF, B - BGP

OSPF Sub Type Codes: O - Intra, Oi - Inter, O1 - Type1 external, O2 - Type2 external

Type IPv6 Prefix Next Hop Router Interface Dis/Metric

C 2000:4::/64 :: ethe 3/2 0/0

S 2001:DB8::/16 :: tunnel

6 1/1

S 2001:DB8:1234::/32 ::

Displaying the IPv6 route table

FastIron Ethernet Switch Layer 3 Routing Configuration Guide

199

53-1003087-04

Advertising