Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 648)

Syslog
When the management VRF is configured, the Syslog module sends log messages only through the
ports belonging to the management VRF and the out-of-band management port.
Any change in the management VRF configuration will be immediately effective for Syslog.
NOTE
The Syslog source interface configuration command ip syslog source-interface must be compatible
with the management VRF configuration.
Configuring a global management VRF
To configure a VRF as a global management VRF, en ter the following command.
device(config)# management-vrf mvrf
Syntax: [no] management-vrf vrf-name
The vrf-name parameter specifies the name of the pre-configured VRF. If the VRF is not pre-
configured, the command execution fails and displays the following error message.
Error - VRF <vrf-name>
doesn't exist
When the management VRF is configured, the software generates the following Syslog message.
SYSLOG: VRF <vrf-name>
has been configured as management-vrf
Enter the no form of the command to remove the management VRF. When the management VRF is
deleted, the software generates the following Syslog message.
SYSLOG: VRF <vrf-name>
has been un-configured as management-vrf
Syslog
648 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04