Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 667)

use-v2-checksum
Enables the v2 checksum computation method for VRRPv3. The no form of this command enables the
default v3 checksum computation method in VRRPv3.
Syntax use-v2-checksum
no use-v2-checksum
Command Default VRRPv3 uses v3 checksum computation method.
Modes VRRP configuration mode
Usage Guidelines Some non-Brocade devices only use the v2 checksum computation method in VRRPv3. This command
enables v2 checksum computation method in VRRPv3 and provides interoperability with these non-
Brocade devices.
Examples The following example shows the v2 checksum computation method enabled in IPv4 and IPv6 VRRPv3
instances.
IPv6 :
Brocade(config)# interface ve 3
Brocade(config-vif-3)# ipv6 vrrp vrid 2
Brocade(config-vif-3-vrid-2)# use-v2-checksum
IPv4 :
Brocade(config)# interface ve 3
Brocade(config-vif-3)# ipv4 vrrp vrid 2
Brocade(config-vif-3-vrid-2)# version v3
Brocade(config-vif-3-vrid-2)# use-v2-checksum
History
Release version Command history
08.0.01 This command was introduced for IPv6 VRRPv3
08.0.10b This command was introduced for IPv4 VRRPv3
use-v2-checksum
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 667
53-1003087-04