Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 549)

show ipv6 bgp output descriptions (Continued) TABLE 106
This field... Displays...
Number of BGP Routes
matching display condition
(appears in display that
matches specified and
longer prefixes) The number of routes that matched the display parameters you entered. This is the
number of routes displayed by the command.
Status codes A list of the characters the display uses to indicate the route’s status. The status
code appears in the left column of the display, to the left of each route. The status
codes are described in the command’s output.
Origin codes A character the display uses to indicate the route’s origin. The origin code appears to
the right of the AS path (Path field). The origin codes are described in the
command’s output.
Network The network prefix and prefix length.
Next Hop The next-hop router for reaching the network from the device.
MED The value of the route’s MED attribute. If the route does not have a metric, this field
is blank.
LocPrf The degree of preference for this route relative to other routes in the local AS. When
the BGP4+ algorithm compares routes on the basis of local preferences, the route
with the higher local preference is chosen. The preference can have a value from 0 -
4294967295.
Weight The value that this device associates with routes from a specific neighbor. For
example, if the receives routes to the same destination from two BGP4+ neighbors,
the prefers the route from the neighbor with the larger weight.
Path The route’s AS path.
Displaying BGP4+ route-attribute entries
The route-attribute entries table lists sets of BGP4+ attributes stored in the device’s memory. Each set
of attributes is unique and can be associated with one or more routes. In fact, the typically has fewer
route attribute entries than routes.
To display the IPv6 route-attribute entries table, enter the following command.
device# show ipv6 bgp attribute-entries
Total number of BGP Attribute Entries: 4
1 Next Hop : :: MED :1
Origin:IGP
Originator:0.0.0.0 Cluster List:None
Aggregator:AS Number :0 Router-ID:0.0.0.0 Atomic:None
Local Pref:100 Communities:Internet
AS Path : (length 0)
AsPathLen: 0 AsNum: 0, SegmentNum: 0, Neighboring As: 1, Source As 0
Address: 0x2a8bd092 Hash:364 (0x1000000)
Links: 0x0, 0x0
Reference Counts: 2:0:4, Magic: 3
Displaying BGP4+ route-attribute entries
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 549
53-1003087-04