Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 357)

show ipv6 ospf interface brief output descriptions (Continued) TABLE 75
This field Displays
Status The status of the link and the protocol. Possible status include the following:
• Up.
• Down.
Type The type of OSPFv3 circuit running on the interface. Possible types include the following:
• BCST- Broadcast interface type
• P2P- Point-to-point interface type
• UNK- The interface type is not known at this time
Cost The overhead required to send a packet across an interface.
State The state of the interface. Possible states include the following:
• DR - The interface is functioning as the Designated Router for OSPFv3.
• BDR - The interface is functioning as the Backup Designated Router for OSPFv3.
• Loopback - The interface is functioning as a loopback interface.
• P2P - The interface is functioning as a point-to-point interface.
• Passive - The interface is up but it does not take part in forming an adjacency.
• Waiting - The interface is trying to determine the identity of the BDR for the network.
• None - The interface does not take part in the OSPF interface state machine.
• Down - The interface is unusable. No protocol traffic can be sent or received on such a interface.
• DR other - The interface is a broadcast or NBMA network on which another router is selected to
be the DR.
Nbrs (F/C) The number of adjacent neighbor routers. The number to the left of the "/" are the neighbor routers
that are fully adjacent and the number to the right represents all adjacent neighbor routers.
Displaying IPv6 OSPFv3 interface information in full mode
You can display detailed information about all OSPFv3 interfaces by using the show ipv6 ospf
interface command, as the following truncated example illustrates.
device#show ipv6 ospf interface
e 2/3/1 admin down, oper down, IPv6 enabled
IPv6 Address:
Area ID 0.0.0.200, Cost 1, Type BROADCAST
MTU: 10178
State DOWN, Transmit Delay 1 sec, Priority 1
Timer intervals :
Hello 10, Hello Jitter 10 Dead 40, Retransmit 5
e 4/3/1 admin up, oper up, IPv6 enabled
IPv6 Address:
fe80::214:ff:fe77:96ff
5100::193:213:111:213/112
5100::193:213:111:0/112
Instance ID 0, Router ID 192.168.98.213
Area ID 0.0.0.200, Cost 1, Type BROADCAST
MTU: 10178
State BDR, Transmit Delay 1 sec, Priority 1, Link-LSA Tx not suppressed
Timer intervals :
Hello 10, Hello Jitter 10 Dead 40, Retransmit 5
Authentication Use: Enabled
KeyRolloverTime(sec): Configured: 300 Current: 0
KeyRolloverState: NotActive
Displaying IPv6 OSPFv3 interface information in full mode
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 357
53-1003087-04