Figure 17 – Brocade VDX 6730 Hardware Reference Manual (Supporting VDX 6730-32 and VDX 6730-76) User Manual
Page 63
Brocade VDX 6730 Hardware Reference Manual
45
53-1002389-06
Replacing a power supply FRU in a Brocade VDX 6730-76
5
FIGURE 17
Inserting the power supply in the Brocade VDX 6730-76
7. Plug the power cord into the power supply to power on the unit.
The power supply will immediately attempt to power up.
CAUTION
If you observe that the switch has powered down approximately two minutes after a power supply
replacement, it is likely because the new power supply has a mismatched airflow. Check your
console for error messages.
8. Verify that the LED on the new power supply displays steady green while the Brocade VDX
6730-76 is operating (see
). If the LED is not steady green, ensure that the power
supply is securely installed and seated properly.
You can enter one of the following commands at the command line prompt to display the power
supply status:
•
show chassis
•
show environment power