Brocade VDX 6730 Hardware Reference Manual (Supporting VDX 6730-32 and VDX 6730-76) - Manual (Page 67)

Brocade VDX 6730 Hardware Reference Manual 49
53-1002389-06
Installing a DC power supply
5
CAUTION
Before beginning the installation, see the precautions in “Regulatory compliance” on page 56.
To install an DC power supply, complete the following steps.
1. If necessary, remove the captive screws located in the upper left and the bottom right of the
device.
2. If the empty power supply bay has a cover plate, remove the two screws near the edges of the
cover plate to unlock the plate, then remove the plate.
3. Remove the DC power supply from its packaging. (refer to Figure 20 )
FIGURE 20 The DC power supply for the Brocade VDX 6730-76
4. Insert the wires into the DC wiring assembly (refer to Figure 21 ).
NOTE
The wire size for DC plus and DC return must be 14AWG minimum
5. Use the wire tightening screws to secure the wires.