Brocade VDX 6730 Hardware Reference Manual (Supporting VDX 6730-32 and VDX 6730-76) - Manual (Page 68)

50 Brocade VDX 6730 Hardware Reference Manual
53-1002389-06
Installing a DC power supply
5
FIGURE 21 The DC wiring assembly
6. With one hand, hold the bar on the front panel of the power supply. With the other hand,
support the underside of the power supply, and insert the power supply into the empty power
supply slot. Press until the supply is completely in the slot, so that the connectors on the back
of the supply are fully engaged with the pins on the power backplane.
CAUTION
Make sure you insert the power supply right-side up. It is possible to insert the supply upside
down, although the supply will not engage with the power backplane when upside down. The
power supply is right-side up when the manufacturer label is on the top.
7. Secure the two screws near the edges of the supply to lock the supply in place (refer to
Figure 22 ).
1 Wire tightening screws 2 Assembly screws
1
2