Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 832)

804 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying VRRP and VRRP-E information for IPv4
advertise backup The IP addresses of Backups that have advertised themselves to this
Brocade device by sending Hello messages.
NOTE: Hello messages from Backups are disabled by default. You must
enable the Hello messages on the Backup for the Backup to
advertise itself to the current Master. Refer to
“Hello interval” on
page 795.
dead-interval The current value of the dead interval. This is the value actually in use by
this interface for the virtual router.
NOTE: This field does not apply to VRRP Owners.
preempt-mode Whether the backup preempt mode is enabled.
NOTE: This field does not apply to VRRP Owners.
virtual ip address The virtual IP addresses that this virtual router is backing up.
backup router ip-addr expires in time The IP addresses of Backups that have advertised themselves to this
Master by sending Hello messages.
The time value indicates how long before the Backup expires. A Backup
expires if you disable the advertise backup option on the Backup or the
Backup becomes unavailable. Otherwise, the Backup’s next Hello
message arrives before the Backup expires. The Hello message resets
the expiration timer.
An expired Backup does not necessarily affect the Master. However, if
you have not disabled the advertise backup option on the Backup, then
the expiration may indicate a problem with the Backup.
NOTE: This field applies only when Hello messages are enabled on the
Backups (using the advertise backup option).
next hello sent in time How long until the Backup sends its next Hello message.
NOTE: This field applies only when this Brocade device is the Master
and the Backup is configured to send Hello messages (the
advertise backup option is enabled).
master router ip-addr expires in time The IP address of the Master and the amount of time until the Master’s
dead interval expires. If the Backup does not receive a Hello message
from the Master by the time the interval expires, either the IP address
listed for the Master will change to the IP address of the new Master, or
this Brocade device itself will become the Master.
NOTE: This field applies only when this Brocade device is a Backup.
track port The interfaces that the virtual router’s interface is tracking. If the link for
a tracked interface goes down, the VRRP or VRRP-E priority of the virtual
router interface is changed, causing the devices to renegotiate for
Master.
NOTE: This field is displayed only if track interfaces are configured for
this virtual router.
short-path-forwarding Displays information about whether VRRP-E Extension for Server
Virtualization is enabled or disabled.
TABLE 172 CLI display of VRRP or VRRP-E detailed information (Continued)
This field... Displays...