Brocade ICX 6430-C Compact Switch Hardware Installation Guide - Manual (Page 24)

Rack mount installation
The devices use stationary mounting when mounted in a rack. The rack-mount kit is not included with
the device and is available to order separately.
DANGER
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.
CAUTION
Ensure that a minimum of 7.62 cm (3 in.) of space above the device and between the front and
the back of the device and walls or other obstructions for proper airflow.
NOTE
You need a #2 Phillips screwdriver for rack mount installation.
Complete the following steps to mount devices in rack.
1. Remove the rack mount kit from the shipping carton. The kit contains two L-shaped mounting
brackets and six sink-head screws.
2. Using a Phillips screwdriver, attach the mounting brackets to the sides of the device using six
sink-head screws.
FIGURE 8 Attaching the mounting brackets for an ICX 6430-C device
3. Remove the two-post rack kit from the shipping carton. The kit contains four rack-mounting
screws and four cage nuts.
4. Insert the cage nuts in the two-post rack where you want to mount the device. See the figure
above.
Rack mount installation
22 Brocade ICX 6430-C Compact Switch Hardware Installation Guide
53-1003080-01