Brocade ICX 6430-C Compact Switch Hardware Installation Guide - Manual (Page 25)

5. Using a Phillips screwdriver, mount the device in a two-post rack using four rack-mounting screws,
as illustrated in the figure below.
1 Rack-mounting screws
2 Cage nuts
FIGURE 9 Installing the device in a two-post rack
6. If installing a single device only, go to the “Powering on the system” task. If installing multiple
devices, mount them in the rack, one below the other.
Wall mount installation
Use the following items to wall mount the device directly to a wall:
• #2 Phillips screwdriver
• Hammer
• Drill
• Wall mount anchors
• Wall mount screws
• Wall Mount Holes Location template
• tape
To mount the device to a wall using the wall mount brackets, see the “Wall mount installation using wall
mount brackets” task.
NOTE
When mounting the device on a wall, Brocade recommends that you mount the device with the port side
down.
Complete the following steps to mount the device directly to a wall.
Wall mount installation
Brocade ICX 6430-C Compact Switch Hardware Installation Guide 23
53-1003080-01