Burcam 105 Series Submersible Deep Well Pumps or SUB-PACS v.2 - Manual (Page 2)

SAFETY INSTRUCTIONS:
This fine pump that you have just purchased is manufactured with the highest quality
materials and workmanship. Before installation and operation, we recommend the
following procedures:
A
B
C
D
E
2
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO ENSURE YOU
COMPLY WITH THE REGULATIONS. THESE CODES HAVE BEEN DESIGNED WITH YOUR
SAFETY IN MIND.
WE RECOMMEND THAT A DEDICATED CIRCUIT BE WIRED FROM THE HOME ELECTRI-
CAL DISTRIBUTION PANEL PROPERLY PROTECTED WITH A FUSE OR A CIRCUIT
BREAKER. WE ALSO RECOMMEND THAT A GROUND FAULT CIRCUIT BE USED.
CONSULT A LICENSED ELECTRICIAN FOR ALL WIRING. IN ADDITION, MAKE SURE THAT
THE POWER SOURCE VOLTAGE MATCH THE MOTOR VOLTAGE SPECIFICATION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE
POWER CONNECTED.
ENSURE THAT THE PUMP AND PIPING SYSTEM IS PROTECTED AGAINST BELOW
FREEZING TEMPERATURES. PUMP DISCHARGE PIPING MUST BE INSTALLED BELOW
THE FROST LEVEL TO YOUR AREA.
ENSURE THAT THE WELL AND THE WATER BEING PUMPED IS FREE FROM SAND. HAVE
YOUR WELL TEST PUMPED TO ENSURE THAT THE WATER IS CLEAR. LARGE AMOUNTS
OF SAND WILL CLOG THE PIPING AND WATERWAYS. WARRANTY IS VOID IF SAND OR
OTHER ABRASIVES ARE DETERMINED AS THE CAUSE OF PUMP FAILURE.
General instructions:
Your submersible pump is a high quality design but, should be installed in a well that is
clean, straight, and of sufficient capacity. Never install your submersible pump where it is
resting on the bottom of the well. A clearance of 10 feet (3.0m) from the bottom of well is
recommended. If the well does not have an appropriate water recovery capacity, a liquid level
control or a L.O.P. pressure switch have to be install.
The 3 wired (+ ground) model, submersible pump is supplied with a motor control box.
This control box should be installed in a clean dry location, in vicinity of the pressure tank.
The dedicated electrical circuit should have its own fused disconnect switch in the line
leading to the pressure switch.
YOUR OWNER’S MANUAL WILL DISPLAY A NUMBER OF DIAGRAMS AND PICTURES
TO HELP YOU WITH YOUR INSTALLATION.