Burcam 506518SS SW STAINLESS STEEL JET PUMP 3/4HP 115/230V - Manual (Page 10)

TROUBLE SHOOTING GUIDE CHECKLIST
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE POWER
CONNECTED. DON’T JUST UNSCREW THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER
FROM THE RECEPTACLE.
TROUBLE PROBABLE CAUSE ACTION
Switch is off position
Blown fuse
Tripped breaker
Dirty pressure switch
Defective pressure switch
Defective motor
Pump not primed
Leaky suction line
Foot valve plugged
Ejector nozzle clogged
Water level below foot valve
Suction lift to great
Improper voltage
Water level below foot valve
Ejector nozzle clogged
Excessive friction in pipe
Improper voltage
Leaky discharge line
Motor not up to normal speed
Improper setting of pressure switch
Ejector nozzle clogged
Pressure tank waterlogged
Leaky foot valve
Leaky suction line
Foot valve do not close properly
Pressure switch out of adjustment
Leaky discharge line (toilet etc.)
Leaky suction line
Gaz in water
Airlogged tank (galvanized)
Turn switch to on position
Replace
Reset
Clean
Replace
Replace
Prime with clean water
Check pipe and pipe connections
Clean
Clean
Check foot valve level
Water level lower than lift capacity
Check voltage
Check foot valve level
Clean
Too small or dirty pipe
Check voltage
Check all pipes for leak
Check power cable and voltage
Reset or replace
Clean
Drain tank and restart
Replace
Check pipe and pipe connections
Clean or replace
Adjust on/off setting
Check all pipes for leak
Check pipe and pipe connections
Check and consult factory
Replace air volume control
TO THE END CONSUMER
If you have any problems with the product, before advising the store, where you’ve purchased the
pump, please contact us at 514 337-4415 , and ask for our sales department, and they will be pleased to
help you with any questions you might have, concerning your installation.
Motor does
not run.
Motor runs
but no water is
delivered.
Pump does not
deliver to full
capacity.
Pump does not
shut off.
Pump starts
and stop too
often.
Air spurts from
fawcets.
10