Elitegroup G733 - Manual (Page 33)

Do not use benzene, thinners, or cleaners with detergent. Only use DVD-ROM cleaning kits.
Do not bend or drop the discs.
Loading a Disc
To play a CD disc, follow the instructions listed below.
Push the CD-ROM, DVD-ROM, Combo Drive or DVD Dual eject button on the CD drive door.
Gently pull the tray all the way out.
Carefully lift the disc by the edges and make sure the shiny surface is face down (the side with
no writing on it). Carefully insert the disc onto the tray. Push the disc down gently so that it
snaps onto the center ring.
Push the tray back into the drive.
To remove a disc, do the following:
Check the LED display and make sure that the computer is not accessing the CD-ROM, DVD-
ROM, Combo Drive or DVD Dual drive.
Push the eject button and pull the tray all the way out.
Carefully pick up the disc by the edges and – while pressing down on the center ring – remove
the CD disk from the tray.
Do not insert any foreign objects into the disc tray. If you experience difficulty when ejecting the CD
disk tray, stretch a paper clip (or use a pin or a thin metal rod) and insert it into the emergency eject
hole located on the right side of the front panel. The CD disk tray should eject immediately. This
procedure can also be used to remove a CD from the drive when the Notebook is powered off.
PCMCIA Cards and Expansion Sockets
The Notebook features one PCMCIA expansion socket design to interface with one Type II card.
Inserting a PCMCIA Card
The computer will emit a medium tone followed by a high tone when a PC card is inserted. When
you eject a card, the computer will emit a high tone followed by a medium tone. You can insert and
remove a PC card whether the computer is turned On or Off.
Follow these instructions to insert a PCMCIA card:
Hold the PCMCIA card with the arrow side up and the connector side toward the socket.
25