A b c d, Figure. 4 – Hired-Hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Rev 12-07 User Manual
Page 12
Part No. 4801-5169 Rev 12-07
Rollup Curtain System
Page 12
6.4 Back Windpipes
Windpipes keep curtains in place during high wind and provide mechanical support when curtain is rolled
up or down. Wind pipes are first installed in back of rollup curtain system.
1. Place pipe in grooves in brackets (A).
2. Slide wind pipe upward until opposite end of wind pipe is above bottom bracket (B). If installing a
double stack system, make sure that wind pipe aligns with slot of middle bracket.
3. Insert end of wind pipe through hole of bottom bracket (C).
4. Install clamp to middle bracket with #14-1 Tek screws to secure wind pipe in place (D). Install screws
through top and bottom brackets to secure windpipe (D).
5. Repeat steps A-D to install back windpipes to system.
A B
C
D
Stringer shown as hidden line
to reveal windpipe.
Figure. 4
NOTE: Single system installs by same procedure
except there is no middle stringer.